Clothes Dryer User Manual

27
TO REPLACE ROTATIONAL SENSOR SWITCH
1. Discontinue electrical power to the dryer.
2. Remove the magnetic rotational sensor switch from the bracket by loosening the nuts.
3. Depress the tabs on the rotational sensor harness plug and pull apart, then remove the sensor switch.
4. To install a new sensor switch, connect the plug of the new sensor switch to the sensor harness.
5. Place one (1) adjustment nut onto the sensor switch.
6. Place the second adjustment nut on, but DO NOT tighten. The magnet on the rear teflon plate and the
sensor switch must be in a horizontal line to one another.
7. The gap between the magnet and the sensor switch must be 1/8 inch.
8. Tighten the adjustment nuts installed in Step #5 and Step #6.
9. Reestablish electrical power to the dryer.