User manual

Installing the Campus-RS Fractional Card
2-2 Campus-RS Fractional Interface Card User Manual
To install the Fractional Interface Card into a Campus-Star chassis:
1 Slide the card into the guide rails in the desired slot on the rear of the
Campus-Star chassis.
2 Gently press the card into place until it is seated firmly in the rear
connector.
3 Use the two screws on the card to secure it into place.
4 Install a Campus-RS Line Unit to work with the interface card, according
to the instructions in the Campus-RS Line Unit User Manual.
5 Use a data cable to connect the data port to your host equipment. See
“Pinouts” on page A-3 for a listing of each type of data port.
620
D
S
X
-1/T
C
FG
DSX-1
620
D
S
X
-1/T
C
F
G
DSX-1
Campus-RS Fractional Interface card
Campus-Star chassis