User manual

Installing the Campus-RS Fractional Card
Campus-RS Fractional Interface Card User Manual 2-3
INSTALLING THE CARD IN A CAMPUS-RS
D
ESKTOP UNIT
To install the Fractional Interface Card into a Campus-RS Desktop Unit
chassis:
1 Slide the card into the guide rails in the rear of the desktop unit.
2 Gently press the card in until it is seated firmly in the rear connector.
3 Use the two screws on the card to secure it into place.
4 Use a data cable to connect the data port to your host equipment. See
“Pinouts” on page A-3 for a listing of each type of data port.
5 Connect the desktop unit to an HDSL line, according to the instructions
in the Campus-RS Desktop Unit User Manual.
Turn off the power to the desktop unit before you install the
card. Installing the card with the power on may cause damage
to the desktop unit, the card, or both.
CAMPUS-RS
CONSOLE
LINE
Guide rail
Campus-RS Fractional
Interface card
Campus desktop chassis
120 VAC@60Hz
or 220 VAC@50Hz
.2A Max
FRACTIONAL V.35