User manual

Setting Up the Campus-RS System
3-2 Campus-RS Fractional Interface Card User Manual
The figure below shows the LCD and menu buttons on the Campus-RS
Desktop Unit. See the Campus-Star User Manual for the location of the LCD
and menu buttons on the CMU.
SET THE HDSL OPERATING MODE
The Fractional Interface Card is set to operate in Standard Mode with a T1
(1.544 Mbps) HDSL Rate. This is compatible with other Campus-RS
products and with Campus-T1 Desktop Units and Line Units. If this is the
desired setting for your system, proceed to “Set the Primary Timing Source”
on page 3-5. Otherwise, follow the steps in this section to adjust the HDSL
transmission rate.
You can also use an ASCII terminal to set the HDSL Operating Mode. For
instructions, see “Setting the HDSL Operating Mode” on page 5-9.
To set the HDSL Operating Mode:
1 Press Escape until Campus I/F Card: FRAC displays.
2 Press Next until HDSL LINK CONFIG & STATUS displays, then press
Enter. OPERATING MODE
displays.
3 Continue with “Selecting a Standard HDSL Rate” or “Selecting
Extended Mode Parameters,” depending on the HDSL mode you want
to set.
Next
Enter
Escape
CAMPUS RS
HDSL
Test
Port
LCD Menu buttons