User manual

Setting Up the Campus-RS System
Campus-RS Fractional Interface Card User Manual 3-3
Selecting a Standard HDSL Rate
This section continues from Step 3 in the previous section to set a Standard
Mode HDSL Rate.
Choose from the following settings:
• T1
• E1
• 768
To set the Standard Mode HDSL Rate:
1 If the Operating Mode is set to Standard Mode, proceed to Step 3.
Otherwise, press Enter.
2 Press Next until the LCD displays STANDARD, then press Enter. The
Operating Mode changes to Standard Mode.
3 Press Next until HDSL RATE displays, then press Enter.
4 Press Next until the desired HDSL transmission rate displays, then
press Enter.
To continue setting up the system, proceed to “Set the Primary Timing
Source” on page 3-5.