User manual

Campus-RS Fractional Interface Card User Manual 4-1
4
CONFIGURING
AND
MONITORING
THROUGH THE LCD
You can configure the Campus-RS Fractional Interface Card and view system
information using the LCD and menu buttons located on the front of the
Campus-RS Desktop Unit or a CMU installed in the Campus-Star chassis.
This chapter describes how to use the LCD to set the individual configuration
options.
You can also perform these functions through an ASCII terminal connected
to the Campus-RS Desktop Unit or a Campus-RS Line Unit installed in the
Campus-Star. To use an ASCII terminal to configure the system, see
Chapter 5, “Configuring with an ASCII Terminal.” To view system and
status information, see Chapter 6, “View Information and Status.”
For Information About: See Page
Navigating the LCD Menus 4-2
Restoring the System to Default Values 4-4
Setting the Data Rate 4-4
Inverting the Transmit Clock 4-10
Inverting Data Signals 4-11
Configuring Output Control Signals 4-12
Configuring as a Master or Slave Unit 4-14
Viewing and Configuring Alarms 4-15
Configuring Loopbacks 4-20
Viewing System Information 4-22