User manual

Configuring and Monitoring Through the LCD
Campus-RS Fractional Interface Card User Manual 4-9
There are two steps to setting the data rate:
• setting the Extended Mode Loop Configuration and HDSL Rate, as
described in “Selecting Extended Mode Parameters” on page 3-4
• setting the rate multiplier
Set the Rate Multiplier
The Rate Multiplier determines the size of each data packet that is transmitted
or received through the data port. It can be set to one of the following:
• 64 KBPS
• 56 KBPS
To set the Rate Multiplier:
1 Press Escape until CAMPUS RS I/F: FRAC displays.
2 Press Next until DATA PORT CONFIG & STATUS displays, then press
Enter. RATE MULTIPLIER displays.
3 Press Enter. The current rate multiplier displays.
4 Press Next until the desired option displays, then press Enter.
RATE MULTIPLIER along with the new setting display.
1856 1624 1856 3712 3248 3712
1920 1680 1920 3840 3360 3840
1984 1736 1984 3968 3472 3968
2048 1792 2048 4096 3584 4096
2112 1848 2112 4224 3696 4224
2176 1904 2176 4352 3808 4352
2240 1960 2240 4480 3920 4480
2304 2016 2304 4608 4032 4608
Data port rates available
according to Rate
Multiplier selection
Data port rates available
according to Rate
Multiplier selection
HDSL Rates
for 1 Loop
56K Rate
Multiplier
64K Rate
Multiplier
HDSL Rates
for 2 Loops
56K Rate
Multiplier
64K Rate
Multiplier