User manual

Configuring and Monitoring Through the LCD
Campus-RS Fractional Interface Card User Manual 4-13
– DSR follows the state of the Data Terminal Ready (DTR) input
signal. When the DTR input is turned on, the DSR output is turned
on. When the DTR input is turned off, the DSR output is turned off.
This type of operation is consistent with standard operation for
non-switched communications equipment operating on a dedicated
private channel, such as HDSL.
– CTS follows the state of the Request to Send (RTS) input signal.
When the RTS input is turned on, the CTS output is turned on. When
the RTS input is turned off, the CTS output is turned off. This type
of operation is consistent with standard operation for non-switched
communications equipment operating on a dedicated private
channel, such as HDSL.
To configure the control signal options to the desired settings:
1 Press Escape until CAMPUS RS I/F: FRAC displays.
2 Press Next until DATA PORT CONFIG & STATUS displays, then press
Enter. RATE MULTIPLIER displays.
3 Press Next until CONFIGURE OUTPUT CONTROL SIGNALS
displays, then press Enter. The current output control signal settings,
with the CTS setting flashing, display.
4 Press Next until the signal you want to change is flashing.
5 Press Enter until the desired setting displays, then press Next.
6 Do one of the following:
• Press Next to select another output control signal, or
• Press Escape to exit.