User manual

Configuring with an ASCII Terminal
5-2 Campus-RS Fractional Interface Card User Manual
CONNECTING TO AN ASCII TERMINAL
To connect the Campus-RS Fractional Interface Card to an ASCII terminal:
1 Plug the console adapter into the standard 9-pin COM port on the ASCII
terminal and tighten the attached screws until they are snug. Skip this
step if the ASCII terminal provides an RJ48 jack.
2 Plug one end of the console cable into the console adapter, then do one
of the following:
• plug the other end of the console cable into the console port on the
desktop unit.
ASCII terminal
9-pin COM port
120 VAC@60Hz
or 220 VAC@50Hz
.2A Max
Campus desktop chassis
Console port
Cable
F
RA
C
TIO
N
AL
V.3 5