User manual

Configuring with an ASCII Terminal
Campus-RS Fractional Interface Card User Manual 5-5
If the system does not respond when you attempt to log on, ensure that
hardware flow control is turned off on the ASCII terminal.
Logging Onto a Remote Campus Unit
1 Press the on the ASCII terminal keyboard several times until
the baud rate is established and the Logon Password screen displays on
the terminal monitor.
2 Press to log on. If you have changed the password, type your
password then press . The Main Menu displays.
3 Press then press .
The menu header changes to indicate the remote unit ID as the local unit,
and local unit ID as the remote. Although the ASCII terminal is
physically connected to the local unit, it acts as if it were connected to the
remote unit. The prompt changes to REMOTE LOGON PASSWORD.
The screens and procedures on the Remote Main Menu are identical to
those on the Local Main Menu, except the REMOTE LOGON option is
unavailable.
July 01, 2002 PAIRGAIN TECHNOLOGIES, CAMPUS RS, Version 4.3K 00:07:59
Local Unit ID: Campus V.35 Unit #19 Local I/F: FRAC V.35
Remote Unit ID: Campus V.35 Unit #27 Remote I/F: FRAC V.35
Circuit ID: Network #13
MAIN MENU
1) SYSTEM STATUS
2) DATA PORT SETTINGS
3) SYSTEM SETTINGS
4) DIAGNOSTICS
5) REMOTE LOGON
(L)ogout
ENTER CHOICE>
SPACEBAR
ENTER
ENTER
5
ENTER