User manual

Configuring with an ASCII Terminal

Campus-RS Fractional Interface Card User Manual 5-11

To set the Standard Mode HDSL Rate:

1 If the terminal is set to the Extended Mode HDSL Parameters menu, type

then press . Otherwise, skip this step.

2 From the Standard Mode HDSL Parameters menu, type then press

. The HDSL Rate option changes to the next in the list of HDSL

Rates.

3 Repeat the previous step until the HDSL Rate option is set to the desired

setting.

4 Type then press to save the new HDSL Rate to NVRAM and

exit the HDSL Parameters menu.

Selecting an Extended Mode

This section continues from Step 3 on page 5-10 to set an Extended HDSL

mode.

To set an Extended Mode HDSL Rate, you must:

• Set the Extended Mode Loop Configuration to 1 Loop or 2 Loops,

depending on the physical layout of your HDSL network.

• Set the Extended Mode HDSL Rate to one of the options determined by

the Extended Mode Loop Configuration:

– 1 Loop HDSL Rate settings are between 64 kbps and 2.304 Mbps,

in 64 kbps increments

– 2 Loop HDSL Rate settings are between 256 kbps and 4.608 Mbps,

in 128 kbps increments

For the 2 Loop HDSL configuration, specific revisions of

the Fractional Interface Card only support a top rate of

2.304 Mbps configuration. Contact ADC for additional

information regarding the affected part numbers.

1 ENTER

ENTER

R ENTER