User manual

Configuring with an ASCII Terminal
5-12 Campus-RS Fractional Interface Card User Manual
1 From the Standard Mode HDSL Parameters menu, type then press
. The HDSL Operating Mode options changes from Standard
Mode to Extended Mode. If the terminal is already set to the Extended
Mode HDSL Parameters menu, skip this step.
2 To change the HDSL Loop Mode, type then press . The HDSL
Loop Mode changes to the next available setting.
3 Type then press . The Select HDSL High Rate (if the HDSL
Loop Mode is set to 1 Loop) or Select HDSL Low Rate (if the HDSL
Loop Mode is set to 2 Loops) menu displays.
1
ENTER
July 01, 2002 PAIRGAIN TECHNOLOGIES, CAMPUS RS, Version 4.3K 00:07:59
Local Unit ID: Campus V.35 Unit #19 Local I/F: FRAC V.35
Remote Unit ID: Campus V.35 Unit #27 Remote I/F: FRAC V.35
Circuit ID: Network #13
EXTENDED MODE HDSL PARAMETERS
1) HDSL Operating Mode: Extended (Standard, Extended)
2) Transceiver Mode: Slave (Master, Slave, Auto)
3) HDSL Loop Mode: 2 Loops (1 Loop, 2 Loops)*
4) HDSL Rate: 256
*Note:
1 Loop = single loop, full duplex
2 Loops = two loops, full duplex
Changes will not be effective until this menu is exited!
(R)eturn (M)ain Menu
ENTER CHOICE>
3 ENTER
4 ENTER