User manual

Configuring with an ASCII Terminal
5-16 Campus-RS Fractional Interface Card User Manual
Choose the Data Rate
To set the Data Rate:
1 From the Data Port Settings menu, type then press . The Data
Rate menu displays.
This illustration shows the Data Rate menu for a Fractional Interface
Card set to Standard Mode with a Standard Mode HDSL Rate of T1. If
your Fractional Interface Card is set to a different HDSL Rate, the Data
Rate menu will be different.
2 Type the number for the desired Data Rate then press . The
terminal returns to the Data Port Settings menu and displays the new
Data Rate.
If the Fractional Interface Card is set to Extended HDSL Mode,
the data rate is determined by the Loop Configuration, HDSL
Rate and Rate Multiplier. You cannot set the Data Rate with
the card in Extended HDSL Mode. See “Setting the Data Rate”
on page 4-4 for more information.
1 ENTER
July 01, 2002 PAIRGAIN TECHNOLOGIES, CAMPUS RS, Version 4.3K 00:06:52
Local Unit ID: Campus V.35 Unit #19 Local I/F: FRAC V.35
Remote Unit ID: Campus V.35 Unit #27 Remote I/F: FRAC V.35
Circuit ID: Network #13
SELECT DATA PORT RATE
Current Port Rate: 1536
1) 64 kbps 11) 704 kbps 21) 1344 kbps
2) 128 kbps 12) 768 kbps 22) 1408 kbps
3) 192 kbps 13) 832 kbps 23) 1472 kbps
4) 256 kbps 14) 896 kbps 24) 1536 kbps
5) 320 kbps 15) 960 kbps 25) 1544 kbps
6) 384 kbps 16) 1024 kbps
7) 448 kbps 17) 1088 kbps
8) 512 kbps 18) 1152 kbps
9) 576 kbps 19) 1216 kbps
10) 640 kbps 20) 1280 kbps
(R)eturn (M)ain Menu
ENTER CHOICE>
ENTER