User manual

Configuring with an ASCII Terminal
Campus-RS Fractional Interface Card User Manual 5-27
Setting a Password
A password prevents unauthorized access to Campus configuration options.
Once a password has been set, it must be entered to log on to the system.
Your password can be any combination of up to ten letters or numbers, but
the first character must be a letter. Passwords are case-sensitive.
To set a password:
1 From the System Parameters menu, type then press . The
system prompts you to enter the existing password.
2 If a password has already been set, type the password then press .
If there is no password, just press . The system prompts you to
enter the new password.
If you did not enter the correct password, the system prompts you to enter
it again. If this happens, repeat the previous step.
3 Type the new password, up to ten characters, then press . The
system prompts you to confirm the password.
4 Type the new password again then press . The system displays
the System Parameters menu.
If you did not enter the correct password, the system prompts you to enter
the new password again. Return to Step 3.
Identifying the Unit and Circuit
The Campus system supports two different identifiers:
• the Unit ID identifies the individual Campus unit
• the Circuit ID identifies the individual HDSL circuit, and is the same for
both the local and remote units
If you forget your password and cannot log onto the
Fractional Interface Card, use the LCD to restore the
configuration settings to their default values. This removes
the password. For more information, see “Restoring the
System to Default Values” on page 4-4.
5 ENTER
ENTER
ENTER
ENTER
ENTER