User manual

Configuring with an ASCII Terminal
Campus-RS Fractional Interface Card User Manual 5-31
Enabling V.54 Loopback Support
This section describes how to enable V.54 loopback support. See “V.54
Loopback Support” on page 7-5 for information on using V.54 loopbacks.
Choose between the following:
• Enable enables V.54 loopback support
• Disable disables V.54 loopback support
To enable V.54 loopback support:
1 From the Main Menu, type then press . The Data Port Settings
Menu displays.
2 Type then press . The Data Port Settings menu displays the
new V.54 Loopback setting.
2 ENTER
July 01, 2002 PAIRGAIN TECHNOLOGIES, CAMPUS RS, Version 4.3K 00:06:35
Local Unit ID: Campus V.35 Unit #19 Local I/F: FRAC V.35
Remote Unit ID: Campus V.35 Unit #27 Remote I/F: FRAC V.35
Circuit ID: Network #13
DATA PORT CONFIGURATION
1) Data Rate: 224 Kbps
2) Rate Multiplier: 56K (64K, 56K)
3) Timing Source: Internal (Port, Int, HDSL)
4) Transmit Clock: External (External, Internal)
5) Invert Input Clock: Off (Off, On)
6) Invert Output TX Clock: Off (Off, On)
7) Invert Output RX Clock: Off (Off, On)
8) Invert Data: Off (On, Off)
9) CTS: STD (STD, On, Off)
10) DSR: STD (STD, On, Off)
11) RLSD: Off (STD, On, Off)
12) LT: STD (STD, On, Off)
13) V.54 Loopbacks: Disabled (Disabled, Enabled)
(R)eturn (M)ain Menu
ENTER CHOICE>
1 3
ENTER