User's Manual
Table Of Contents
- Objective
- Module introduction
- Basic Operation
- General
- "Hayes" Mode
- "Point-to-Point" Mode
- "Network" Mode
- Demo Kit Utilization
- Installation and Connection
- WinB900 Software Utilization in Point-to-Point Mode
- The different fields and buttons are described below:
- "Sent Characters" Field
- "Received Characters" Field
- "Test Frames" Selection
- "Characters Count" Field
- Button: "Send"
- Button: "Continuous"
- Button: "Initialization"
- Button: "Stop"
- Button: "Quit"
- "Character Count Sent/Received" Fields
- "Elapsed time" Field
- "Sent/Received/Corrupted Count" Fields
- "Stop on Error" Selection
- Use of the WinB900 Software in Network Mode
- Use of the "Terminal" or "HyperTerminal" Software
- Advanced Operation
- Appendix 1: Schematic Block Diagram
- Appendix 2: Mechanical Drawings
- Appendix 3: Antenna Connection
- A
- Appendix 5: Timing Diagrams
- Appendix 6: Description of the registers
- Appendix 7: Revisions History
32
• "Transmission" Button
This button allows initiating the selected carrier transmission based on the chosen
channel. When this button is selected, a red rectangle appears indicating that the
modem is transmitting.
• "Stop" Button
This button stops transmitting the selected carrier.
• "Quit" Button
This button returns to the Main Window.