Installation & Use USB AV4USB-PC, AV4USB-MAC

AdderView USB Installation and Use Page 22

The hotkey command are summarised below (note that the numbers on the numeric

keypad do not form part of a valid hotkey) :

‘HOTKEYs’ and ‘1’ - selects channel 1

‘HOTKEYs’ and ‘2’ - selects channel 2

‘HOTKEYs’ and ‘3’ - selects channel 3

‘HOTKEYs’ and ‘4’ - selects channel 4

‘HOTKEYs’ and ‘TAB’ - selects the next channel. The next channel may be the next

active channel or the next channel in numerical sequence depending upon the

position of option switch 8 (see section 2.4.3).

‘HOTKEYs’ and ‘A’ - selects autoscan mode where each channel’s video is

displayed for the selected time (see section 2.4.2). To cancel autoscan mode simply

select any fixed channel either by hotkey or by using the front panel button.

‘HOTKEYs’ and ‘0’ – switches off the video signal and displays 0. This will cause

some monitors to go into standby mode or switch off. The video signal can be re-

enabled by selecting a channel.

Examples of common hotkey sequences (assuming CTRL + ALT hotkey option):

To select channel 2:

press

baba

22 release 22

baba

To 'tab through' channels:

press

baba

release

press

release

press

release

vbavba