User guide

12
INSTALLATIONCONFIGURATIONOPERATION
FURTHER
INFORMATION
INDEX
Conguration
INITIAL CONFIGURATION
The conguration, monitoring and management of the ALDV104T transmitter and its
receivers is performed using the in-built AdderLink POD Manager (POD = Proof Of
Display) which is accessible via the network connection using a standard web browser.
Accessing the AdderLink POD Manager
To access the AdderLink POD Manager
1 Use a computer that is directly or indirectly (i.e. via a network switch) connected to
the ALDV104T transmitter. If you need to make a temporary connection, see right
Ü
2 Run a web browser on your computer and enter the IP address of the ALDV104T
transmitter. The default setting is: 192.168.1.22
3 If requested, enter your username and password to log on.
 Note: The default username and password are ‘admin’ and ‘password’ respectively.
 The opening page of the AdderLink POD Manager should be displayed:
Temporary link from
your computer
To temporarily connect a computer to the network port
1 If you need to make a temporary connection for conguration purposes, use a
standard patch cable (cross-over or straight connections are both supported)
to link the Ethernet 10/100 network port ( ) of the transmitter unit to your
computer’s network port.
Logging out
There is no log out option. You merely need to close the browser that you are using to
access the POD Manager.
 Note: If the transmitter has been previously congured and those settings are unknown, see
the Troubleshooting section for details about reverting to the default settings.
HT