Technical data

ePowerSwitch 8XM / 8XS
1. Safety instructions: to read before use!
NOTE
In the following instructions "ePowerSwitch device" refers to both devices ePowerSwitch 8XM and
ePowerSwitch 8XS.
The ePowerSwitch devices can only be installed by qualified people with the following installation and use
instructions. The manufacturer disclaims all responsibility in case of a bad utilization of the ePowerSwitch
devices and particularly any use with equipments that may cause personal injury or material damage.
•
•
•
•
•
•
•
•
•
•
•
•
•
This equipment is designed to be installed on a dedicated circuit that must have a circuit breaker or fuse
protection.
The electrical power sockets used to plug the power cords of the ePowerSwitch devices must be close to
the ePowerSwitch devices and easily accessible.
Check that the power cords, plugs and sockets are in good condition.
The ePowerSwitch devices can only be connected to three-wire 230 VAC (50-60Hz) sockets.
Always plug the ePowerSwitch devices into properly grounded power sockets (two poles plus ground).
Never exceed 10 Amp total load for each group of 4 power outlets of an ePowerSwitch device.
The ePowerSwitch devices are intended for indoor use only. Do NOT install them in an area where
excessive moisture or heat is present.
Always disconnect the 2 (two) power cords of the ePowerSwitch device if you want to intervene on the
ePowerSwitch device or on the equipment powered from the ePowerSwitch device.
The Power Outlets of the ePowerSwitch devices are not circuit breakers! If you want to intervene on
equipments connected to an ePowerSwitch device you must disconnect these equipments from the
ePowerSwitch device.
Do NOT attempt to disassemble the ePowerSwitch devices, they contain potentially hazardous voltages.
The ePowerSwitch devices contain no user serviceable parts and repairs are to be performed by factory
trained service personnel only.
Always use a shielded cable for the Ethernet connection.
English
3