User Manual

Addictive Desert Designs

2007.5 - 2013 Chevy/GMC 1500 & 2500

50” radius bar roof mount

installation instructions

PREPARATION STEPS

1. Disconnect the negative terminal on the battery. With the vehicle on level ground and the

emergency brake set.

2. You will need the following tools:

a. Drill

b. 1/4” Drill Bit

c. 1/4” Rivets (6)

d. Tape Measure

Note: This installation requires 2 people for best results

3. Included in Kit:

a. Right Mount(1)

b. Left Mount(1)

INSTALLATION INSTRUCTIONS

1. Mount light bar into both Roof Mounts to create an assembly.

2. Carefully line up the front side base of the mount with the corner of the cab before it meets the

windshield.

PAGE 1
Addictive Desert Designs 2007.5 - 2013 Chevy/GMC 1500 & 2500 50” radius bar roof mount installation instructions PREPARATION STEPS 1. Disconnect the negative terminal on the battery. With the vehicle on level ground and the emergency brake set. 2. You will need the following tools: a. Drill b. 1/4” Drill Bit c. 1/4” Rivets (6) d. Tape Measure Note: This installation requires 2 people for best results 3. Included in Kit: a. Right Mount(1) b. Left Mount(1) INSTALLATION INSTRUCTIONS 1.
PAGE 2
3. With the bracket in position, mark and drill the three holes with the 1/4” drill bit and install the rivets and bracket according to the rivet tool manufacturer’s instructions. Repeat for the other side.
PAGE 3
4. Wire the light according to instructions included with the light.
PAGE 4
5. Stand back and enjoy your A.D.D. Light Mount. For additional support or technical questions, please call 480.671.0820 or email info@addictivedesertdesigns.com Addictive Desert Designs 4840 E. Jasmine Street Suite 112 Mesa, AZ 85205 www.addictivedesertdesigns.