Instruction Manual

Addictive Desert Designs

2010 – 2014 Ford Raptor

Stealth Front Bumper

Installation instructions

PREPARATION STEPS

1. Disconnect the negative terminal on the battery. With the vehicle on level ground and the

emergency brake set.

2. You will need the following tools:

a. ½” drill bit

b. ¾” wrench

c. ¾” Socket

d. Ratchet

e. 15MM socket and ratchet

f. Sharpie type marking pen

g. Center punch

3. Hardware Included:

a. 8 – ½” x 1 ½” Bolts

b. 8 – ½” Nuts

c. 12 – ½” Flat washers

**2 – 15mm Skid plate Bolts will be re-used in the installation

INSTALLATION INSTRUCTIONS

1. Remove factory Front Bumper and front skid

plate (Keep the 2 – 15mm Skid plate Bolts for

re-use) .

2. Fit the Bumper onto the truck and use the

Sharpie to mark the frame horn to drill the

½” holes. The red arrows are the holes to be

drilled, the blue arrows show the factory

slots. Slots and holes will be opposite for the

Drivers side

PAGE 1
Addictive Desert Designs 2010 – 2014 Ford Raptor Stealth Front Bumper Installation instructions PREPARATION STEPS 1. Disconnect the negative terminal on the battery. With the vehicle on level ground and the emergency brake set. 2. You will need the following tools: a. ½” drill bit b. ¾” wrench c. ¾” Socket d. Ratchet e. 15MM socket and ratchet f. Sharpie type marking pen g. Center punch 3. Hardware Included: a. 8 – ½” x 1 ½” Bolts b. 8 – ½” Nuts c.
PAGE 2
***If you purchased lights that fit behind the bumper, now is a good time to install those into the bumper**** 3. Fit the bumper back onto the truck and attach using the supplied ½” x 1 ½” Bolts (8 ea.), ½” Nuts (8 ea.) and ½” Flat Washers (12 ea.). Leave finger tight until all of the bolts are installed, then tighten to 70 ft./lbs. 4. Attach the lower section using the 2 – 15mm Skid Plate Bolts taken from the factory skid plate. 5. Step back and enjoy your new A.D.D. bumper. 6.
PAGE 3
For additional support or technical questions, please call 480.671.0820 or email info@addictivedesertdesigns.com Addictive Desert Designs 4840 E. Jasmine Street Suite 112 Mesa, AZ 85205 www.addictivedesertdesigns.