User guide

Addictive Desert Designs

2010 – 2013 Ford Raptor

Venom Chase Rack

Installation instructions

PREPARATION STEPS

1. Disconnect the negative terminal on the battery. With the vehicle on level ground and the

emergency brake set.

2. You will need the following tools:

a. 90’ drill

b. ½” drill bit

c. Ratchet

d. ¾” Socket

e. ¾” Wrench

f. Sharpie

g. Utility knife

3. Hardware Included:

a. 6– ½” x 1 ½” Bolts

b. 6 – ½” Nuts

c. 12 – ½” Flat washers

INSTALLATION INSTRUCTIONS

1. Place Venom Chase

Rack into position on

bed cap. Align front

edge of flat channel

to the plastic cover

piece as shown.

PAGE 1
Addictive Desert Designs 2010 – 2013 Ford Raptor Venom Chase Rack Installation instructions PREPARATION STEPS 1. Disconnect the negative terminal on the battery. With the vehicle on level ground and the emergency brake set. 2. You will need the following tools: a. 90’ drill b. ½” drill bit c. Ratchet d. ¾” Socket e. ¾” Wrench f. Sharpie g. Utility knife 3. Hardware Included: a. 6– ½” x 1 ½” Bolts b. 6 – ½” Nuts c. 12 – ½” Flat washers INSTALLATION INSTRUCTIONS 1.
PAGE 2
. Mark the 6 hole locations with sharpie and move the chase rack out of the away. 3. Drill the 6 marked holes with the ½” drill bit and drill. Clean of any burrs in the plastic with utility knife. ***If you purchased lights that fit into the Chase Rack, now is a good time to do the install. **** 4. Fit the Chase Rack onto the truck and attach using the supplied ½” x 1 ½” Bolts (4 ea.), ½” Nuts (4 ea.) and ½” Flat Washers (8 ea.).
PAGE 3
For additional support or technical questions, please call 480.671.0820 or email info@addictivedesertdesigns.com Addictive Desert Designs 4840 E. Jasmine Street Suite 112 Mesa, AZ 85205 www.addictivedesertdesigns.