Specifications

18 Appendix D
SRS Residual Gas Analyzer
The “virtual led” next to the Filament label should be lit before performing a scan. (Note: If your
vacuum chamber is equipped with an external ionization source SRS RGA LabVIEW will let you scan
with the filament off.)
Scanning & Logging Setup Dialog
Click the button labeled “Scan/Log Setup…”
The Scanning & Logging dialog allows you to set up a scan for any of the three scanning modes (analog,
table, histogram) from within a single screen. If you were setting up an analog scan, you would only need
to specify the initial and final mass of the scan range. The default range is 100 AMU. For demonstration,