User Manual

 
 ________________________________________________________________________________________________________________
66

Figure10.11TaskResult
10.5 Viewing the Task Results
OntheTaskListpage,selectacalibratedtask(markedwith"√")and
pressEnterorSelect
Theoverviewofthetaskwillappear.Themaximumerror(AsFoundand
AsLeft)andparametersoftheTaskwilldisplayonthispage(asshownin
Figure10.11).
Youcan
re‐calibratetheUUTbypressingEnterorAsCalasdescribedin
theprevioussection.
Ifyouwanttocrea teasimilartaskbasedonthecurrenttask,youcan
pressSave As tore‐edittheparametersofthetaskandsavethem.
Youcanseethedetaildataoftask
bypressingResulttheerrorgraphand
calibrationdatawillappear.Ifbothas‐foundandas‐leftareavailable,the
arrowsontopofpagewillbeenabled.Pressthenavigationkeys
Left/Right toscrollthepage,andtheas‐foundandas‐leftcalibra tiondata
willdisplay.
PressEsc orBack toexit
thetaskresults.