User`s guide

Addonics Technologies – Jupiter Combo Hard Drive User’s Guide v1.0 7
Step 1
Separate the top from the bottom cover
of the drive enclosure by loosening the
screw as shown on the photo.
Step 2
(IDE HDD)
Align the male IDE connector on the
2.5” hard drive with the female IDE
connector on the PCB.
(SATA HDD)
Align the SATA connector in the 2.5”
hard drive with the SATA connector on
the PCB.
Push the hard drive till the connector pins on the hard drive is fully seated
inside the connector on the PCB.