Addonics T E C H N O L O G I E S Pocket UDD (Ultra DigiDrive) USB Firewire Users Guide Revision 1.
FCC Warning Statement This equipment has been tested and found to comply with the limits for a class B digital device pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy. If not installed and used in accordance with the instructions, it may cause harmful interference to radio communications.
Chapter 1 Preface This is a Preliminary version of the manual intended to provide advance information on the Addonics Technologies’ external Pocket UDD. The information is as complete and as accurate as possible as of the publication date, but will be superseded and updated periodically by revised manuals. The contents are subject to change without notice. General Information Thank you for purchasing Addonics Pocket UDD.
Chapter 2 Getting Started Make sure that you have the following items: For Pocket UDD with USB2.0 Cable (model: AEPUDDU) l One Pocket UDD l One USB2.0 cable l Driver’s Diskette l This User Guide For Pocket UDD with USB2.0 Cable (model: AEPUDDU9) l One Pocket UDD l One USB2.
Chapter 3 Operation of the Pocket UDD You must have a media inside the Pocket DigiDrive when it is the first time to install this device to your computer. The pocket UDD is designed not to draw any power when there is no media inserted. So the LED light will remain off even the device is connected to the computer. Use the following procedures to add or remove the media from the Pocket UDD. 1.
(Any Flash media below is compatible to use with the Pocket UDD, Using the optional Addonics CF DigiAdapter and 4-in-1 DigiAdapter or equivalent third party adapter) Note: To remove the media from the Pocket UDD, use the safe Removal icon from the system tray. Media To use the Pocket UDD for other media other than PCMCIA hard drive and ATA flash, the Addonics DigiAdapters are required. These adapters come standard with the AEPUDDU9 and AEPUDDFW9 models and they can also be purchased separately.
USB Cable Installation Attach the USB-IDE cable’s “MC 36 Connector” to your Addonics Pocket UDD firm and securely – you should not be able to disconnect the cable without pressing the release notch. USB driver Installation For Win98 and Win98SE Note: § Plug and Play under Windows Me, 2000 and XP § Uses Mass Storage Driver under Windows Me, Windows 2000 and XP 1. 2. 3. 4. 5. Make sure your computer is up and running Verify that all cables are connected.
Firewire Cable Installation Attach the FIREWIRE-IDE cable’s “MC 36 Connector” to your Addonics Pocket UDD firm and securely – you should not be able to disconnect the cable without pressing the release notch. Firewire Pocket UDD Installation For Win98SE, Me, 2000 and XP Make sure your computer is up and running 1. Verify that all cables are connected. 2. Insert the Flash card that you will be using to the Digidrive. 3. Connect the Firewire connector to the Firewire Port.
Technical Support If you need assistance to get your unit functioning properly, please call Addonics Technical Support. Our technical staff will be happy to assist you, but they will need your help to do so. Calling the technical support staff without all the proper information can be both time consuming and frustrating. Here are some tips to help you out: (1) (2) (3) (4) MODEL NUMBER – Please have this number on hand. SYSTEM INFORMATION – Type of computer, peripherals, etc.