Specifications

Chapter 2 27
Setting a Password
Follow these steps:
1. Use the
↑
and
↓
keys to highlight a Set Password parameter
(Supervisor or User) and press the
Enter
key. The password box
appears.
:
2. Type a password. The password may consist of up to seven
characters (A-Z, a-z, 0-9).
Note: Important: Be very careful when typing your password because
the characters do not appear on the screen.
3. Press
Enter
. Retype the password to verify your first entry and press
Enter
.
After setting the password, the computer automatically sets the
chosen password parameter to Enabled.
4. Press
Esc
to go to the Exit menu.
5. Press
Save Change & Exit
to save the password and exit the Setup
Utility.
To change a password, follow the same steps used to set a password.
Removing a Password
Should you want to remove a password, do the following:
1. Use the
↑
and
↓
keys to highlight a Set Password parameter
(Supervisor or User) and press the
Enter
key. The password box
appears
:
2. Enter your current password in the first parameter and then press
Enter
.
3. Press
Enter
twice without entering anything in the next two password