User`s manual

DIGITAL-LOGIC AG MPC40/A/B/C, MPC41 Manual V1.4C
74
Driver location under Hardware manager
6.1.5.1 EEPROM Update utility
An EEPROM is present on the design storing some important information about PCI configuration and a
global unique ID that is required by all 1394 device to be fully compliant.
The MSMW104+ EEPROM is already programmed with the right file to configure PCI registers specific to TI
TSB43AB22 device. Customer could need to reprogram the EEPROM, either because it has been damaged
or to provide a new ID.
The program OHCIROM.EXE with its different options enables a selective update of the EEPROM content.
Please consult chapter 3 to find the location of the tool on the Digital-Logic product CD.
6.1.5.2 Establishing a 1394 Connection under Windows
The following steps are needed to establish a connection to 1394 devices.
A. The device needs first to be plugged into the dedicated FW port.
B. 1394 bus supports plug and play feature, once plugged in, the device will be detected.
C. You can be prompted to install a driver for the connected device. Please use the provided drivers
from the manufacturer. The device drivers may also be in the default driver set from your operating
system and you may need the operating system source.
D. Once the driver be installed, you should normally be able to communicate with the device.
The following figures show the installation process of a compliant IEE1394 hard-disk under Windows 2000.
This is only intended as an example of IEE1394 device under Windows. As said before, your device may
need drivers which are not directly provided by the OS. In that case, you will be prompted to use the avail-
able manufacturer drivers.