Installation guide

ADDONICS TECHNOLOGIES
Model: AD5SAPM
Installation Guide
Front View
Ports 1-5: SATA ports where the SATA drives are
connected
SATA Port: Connect to a SATA host controller which
is Port Multiplier compatible
Side View
Jumper LED connections
Note: When the internal port multiplier (PM) is connected
to a SATA Host controller with SiI3124 or SiI3132
chip, in the RAID BIOS of the host controller, you
will only see one drive and that is the drive
connected to port 1 on the hardware PM.
All the SATA drives connected to the PM will show
in the SATARAID5 Array Manager.
1. Mount the internal SATA Port Multiplier onto the PCI
bracket of any standard desktop or low profile system.
2. Attach the SATA hard drives (up to 5) to ports 1-5 on
the Port Multiplier using SATA cables.
3. Attach a 4-pin floppy power cable from the power supply
unit to the Port Multiplier power connecter.
4. Connect a SATA cable to the Host SATA port of the
Port Multiplier then to the SATA port of the raid
controller.
TECHNICAL SUPPORT
Phone: [phone]
Fax: [phone]
Email: http://www.addonics.com/sales/query/
Internet: http://www.addonics.com
Technical Support (8:30 am to 6:00 pm PST)
Phone: [phone]
Email: http://www.addonics.com/support/query/
Port 1
Port 2
Port 3
Port 4
Port 5
Host SATA Port
4-Pin Floppy
Power Connector