User's Manual

SABRE

™

RANGER 5000 User Guide

RS232 port – debug port

This port is intended for capturing the debug log. The cable length is limited to 10 metres.

Use Belden cable no. 9533 or equivalent.

 Connect the wires as shown below.

NOTE: The sample wires below are used for reference. You may use different colour wires that

met the electrical specifications.

Black wire  terminal block 22 (GND)

Red wire  terminal block 24 (RS232-TX)

White wire  terminal block 23 (RS232-RX).

Figure 10

RS232/RS485 – user port

This is a user configurable port. The user can configure this port to be any of the

following:

 RS232

 RS485 – full duplex

 RS485 – half duplex

RS232

Use Belden cable no. 9533 or equivalent for 3-wire RS232 (RX, TX, GND) or Belden

cable no. 9535 or equivalent for 5-wire RS232 (RX, TX, RTS, CTS, GND). Cable length is

limited to 10 metres.

 Connect the wires as shown below.

NOTE: The sample wires below are used for reference. You may use different colour wires that

met the electrical specifications.

Black wire  terminal block 10 (GND)

Red wire  terminal block 8 (RS232-TX)

White wire  terminal block 11 (RS232-RX)

NOTE: If you use the Belden cable no. 9535 for 5-wire RS232 (RX, TX, RTS, CTS, GND), refer

to figure 7 for the wire connections to the terminal block.