User's Manual

SABRE

™

RANGER 5000 User Guide

6. Fix Optional Mounting Bracket to Sabre™ Ranger 5000

Figure 19

1. See figure 19 above. Place Sabre™ Ranger 5000 terminal with its front face on a flat surface.

2. Attach the bracket body on the rear of Sabre™ Ranger 5000 terminal.

NOTE: There are five holes at the base of the bracket body. The wire loop-hole as shown on

the enlarged view should be placed along the upper edge of the terminal. See figure 19 and its

enlarged view.

3. Align the four holes, and fasten to Sabre™ Ranger 5000 terminal using the washers (4x)

and the socket head cap screws (M8 x 14mm - 4x) with a hex L-key.

4. Align the bracket wall to the bracket body . See figure 19. Notice the upper holes on the

bracket wall align to the slots on the bracket wall and the lower holes align to the holes below

the slots of the bracket body.

5. Use the washers (4x) , the split washers (4x) and the socket head screws (M8 x 14mm -

4x) to assemble to .

NOTE: Do not fully tighten the screws to assemble to with a hex L-key, fasten the screws

finger tight only as you need to adjust its actual position according to the satellite location later.