User's Manual

10
st e P 4
If an RCA connection is unavailable, use the provided TV MICROPHONE n
to pickup the desired sound source. Plug in the microphone into the Mic Jack
on the rear of the TX260 Transmitter m. Use the velcro strip supplied to attach
the microphone near the loudspeaker m of your TV or stereo.
The microphone will allow you to play the TV at lower volume for other
listeners and will pick up other important sounds like the telephone or doorbell
ringing.
se t t i n G u P t h e rX260 re C e i v e r
st e P 1: in s t a l l t h e re C e i v e r Ba t t e r i e s
Insert the rechargeable battery into the bottom of the RX260 Receiver
(see page 9). Place the receiver into the charger cradle built into the
top of the TX260 Transmitter and let charge overnight. The spare bat-
tery can be plugged into the charging port located on either side of the
transmitter. By keeping the spare battery charged, you can easily swap
batteries when the one in use runs out and always have a fresh battery
ready. A fully charged battery will operate the receiver for approxi-
mately 6 hours, depending on the volume setting. The battery should be
changed when you notice the sound getting weak and noisy. The batter-
ies may be left charging when not in use.
st e P 2: us i n G t h e wFM rX260 re C e i v e r
To use the system, rst check to make sure your TV or audio source is
turned ON. Make sure the receiver battery is fully charged. The RX260
Receiver has an automatic on/off function. When you put the receiver
on, it turns on. When you take the receiver off, it turns off. Rotate the
volume control to adjust the volume to a comfortable level.
Return the receiver to the charger when it is not in use.
ad d i t i o n a l re C e i v e r ad j u s t M e n t s
Balance Control: Use a small screwdriver to adjust the loudness bal-
ance between the left and/or right earphones. See page 9.