Specifications

b.
c.
d.
e.
Disconnect one wire of the fire zone. The CHECK display on
the Security Console and the Zone 4 TRBL LED on the C-COM should
light and the CHK.BYP LED on any Remote Keypad should flash.
A rapidly pulsing tone should be heard from the Security Console's
speaker and a rapidly pulsing buzz should be heard from the
Remote Keypad's buzzer.
Silknce the trouble sounding by keying the security code and
depressing OFF at a console or keypad (or by turning a key at
a key arming station). The sound should‘stop but the visual
LED indications should continue.
Recomfxt tk fire zone wire. All visual fire trouble indications
should go out.
Mmemtarily short the fire zone. A fire alarm should be triggered,
accompanied by a loud rapidly alternating or pulsed rapidly
alternating (depending upon configuration programed) two-tone
siren sound from both the console and any other interior or
exterior speakers used (or by a pulsed bell output). In addition,
the FIRE LED on the Security Console will light and the Zone
4 Alarm LED on the C-CCM will light.
Silence the alarm by using the FIRE TEST/RESET switch on the
C-COM, by entering the security code followed by OFF at a console
or keypad, or by turning the arm/disarm key at a keyswitch arming
station.
WIES:
1. The battery may not be fully charged. If this test
is tried with a low battery there rill not be enough
power to ring bells (sirens operate from the unregulated
12VAC when AC is present anti are unaffected). Let the
battery charge (transformer plugged in) for at least
one-half hour if the battery is low.
2. If the fire zone remains shorted after the alarm is
silenced (such as if a smoke detector were still filled
with smoke),
the system will enter the fire trouble
mode until the short has been eliminated.
When the
zone has restored, the system will return to normal.
8.
'lest the Zone 5 panic circuit by momentarily shorting terminals TB-12
and 13, by operating an external
, zone connected panic switch, or
by depressing both of the POLICE keys on the Security Console. If
tk zone is programned for audible alann, both the console and exterior
speakers should sound [steady two-tone siren sound (slowly alternating
or rapidly alternating
, as a function of sound programmed)]. If
bells are used, a steady bell sound will be produced. The POLICE
LED on the console will light.
These conditions continue after the
short is removed. A message will be transmitted to the central station.
Reset the system by entering tk security code at a console or keypad
or by turning the arm/disarm key at a keyswitch arming station.
If the zone is programmed for silent operation, none of the above
mentioned sounds will be heard. The POLICE LEO may or may not light
as a function of selection of a separate progranxning option for silent
panic.
628-46
723