User`s manual

4)
5)
6)
7)
8)
9)
Enter devices”
BELL 2 OUTPUT
connected to bell 2
Total Current
Device Model #
output, calculate
Device Current X
# of Units
= Standby Alsrm
slsrm currents, then
Xxxxxx
add to get bell 2
Xxxxxx
output currant
d
eubtotsl.
Xxxxxx
Xxxxxx
Xxxxxx
Xxxxxx
Xxxxxx
Bell 2 Output Subtotal (terminals 5 & 6) 2.3amp m=
Xxxxxx
Enter the total polling pOLLING Loop
loop current using
Total Current
Standby Alarm
values calculated in
the polling loop
(E”twwwbh=t mtiinkm smdby&d=m-lumns) P0Lkn9 Loop Subtotal
I
worksheet.
Enter the calculated
eubtotals of all listed
outputs then add to
get combined
current.
These vslues are
fixed.
Enter the calculated
COMBINED AUX. POWER, BELL AND POLLING LOOP
Total Current
Standby Alarm
Aux. Powerl Output Subtotal
I
Aux. Power 2 Output Subtotal
Bell 1 Output Subtotal
Bell 2 Output Subtotal
Polfing Loop Subtotal
Add all subtotals
I
(Cannot axceed 1.0 amp m=. standby; 2.3 amp m=. alarm)
I I
I
~
Includes Z.wire smoke detetior loading on zonas 1 & 2 and ttigger
acuay raws m w enac ve. owever,sin=
tiderament, mdsinwmtin dderisinactive when5140DLMinactive, 5l4ODLMimposes only 15mA
* wmton mww sumh.
.,, ,
~TOTAL POWER SUPPLY LOAD I Total Currem
combined currents
thsn edd to total PCB
Standby Alarm
current.
Comtined aux. wwer, bell and piling Imp total
Total PCB current
Total power supply load
Using the totsl
BATTERY CAPACITY CALCULATION WORKSHEET
calculated power
supply load (step 8),
celculate the battsry
capscity required for
the installation.
10) Using the battsry
capacity from step
9, sslect the
appropriate battery.
(For 24 hour standby followsd by 5 minute fire or 15 minute firehurglary alarm)
Cspacity
Formule Calc Value
Standby Capacity
totaistandby load X24hours X1.1 mntingancy fader
(use total standby Ioad from pravious wo~sheet)
Alarm Capzity total alarm load X O.OWhours (5 minutes)
0.29 houm (t5 minutes)
1(
use total alarm Ioad from previousworksh’act)
I
Total Capacity
A6d standby and alarm capacities
BAITERY SELECTION TABLE
(The following batteries will fit insida the5140XM catinet)
~
Yuasa NP7-12 mnne&2in arallel
Yuasa NP12-12 conne@2in arallel
Yuasa NP7-12 conneti4in arallel
3.4 AH
I
Yuasa NPG18-12 (connect 2 in parallel)
-32–