User`s manual

PROGRAMMING DATA

The programming fields are grouped into three sets (or “pages”), as represented

FIELDS

in the diagram below. The fhst set is awessed as soon as programming mde is

entered. To access the other sets of fields ~ndicated on the programming form by

a”1” or”3 in front of the 2digit field address), press “94. Note that the alpha

wnsoles dsplay the words ALT PROGRAM MODE to indicate the higher set of

fields. To return-to the previous set of fietis, press “99. When programming data

fields, the fields fisted in the table in the ZONE PROGRAMMING section can be

skipped, eince they can be programmed using the user-friendly ZONE

PROGRAMMING Mew Mode.

Code + [a] + [0] + [0] to~enter programming mode

w or W8 + EMT

’94

●:9

“94

$ “:9

To program specific data fields, press p] plus the 2-digit field address,

then make the required entry. The console will beep when a field has been

mmpletely programmed and will automatically dtsplay the neti field in sequewe.

If the number of digits that you enter in the data field is less than the maximum

permitted (ex. phone number), the console displays the last entry and waits. To

proceed, the next data field to be pr~rammed must be entered manually (ex.

press ‘05).

To view the contents of a data field, press [#] plus the 2-digit field

address. The fields entries will be displayed, but no changes can be made.

In case of errors: If an address is improperly entered, the console will &splay

FC If a program entry is improperly entered (for example, a larger number than

that which is permitted), the mnsole display will go blank. In either case, simply re-

enter the correct number.

KEY COMMANDS

●94

NeX’set of fields

“99

Previous set of fields or exit prog

ramming mode

#93

Enter ZonelAph~evice Pragrarnming mode

●98

Exft Programming mode wth installer lo&.out

—49—