Operating instructions

CONNECTIONS
Typical Time-Lapse Recorder Rear Panel
Optional Loop-out to another video device
Typical LCD monitor back
Camera or other video source
OUT
IN
VIDEO AUDIO
To make a normal connection to the monitor, route a cable from a camera or other
video source to one of the BNC jacks or from a PC to the PC jack on the back of
the monitor. Either the left or right BNC jack can be used for input.
The other jack may be connected to another device using the same input signal..
The input circuit of the monitor normally terminates the incoming cable with 75 ,
but these BNC connectors are auto-terminating. When two cables are connected,
the internal termination is switched off, letting the last unit in the system provide
the end termination. The Y/C (S-Video) jacks function this way as well.
Auto Termination
PC
AMC15LCD 9
15-Inch Color Monitor