User guide

– 23 –
SPEED KEYS (MACROS)
General
Information
The "A", "B", "C", and/or "D" key can each be used to activate a
string of commands up to 32 keystrokes (depending on installer
programming). These commands are known as a macro and are
stored in the system's memory. Typical Speed Key functions
include:
• Seldom used but repeatable sequences.
• Arming sequences that involve first bypassing certain zones
before arming.
• Relay activation sequences.
Defining Enter your user code + [#] + [x] (where x is the A, B, C or D key)
and hold the [x] key down until the following appears:
ENTER SPEED KEY "D"
existing sequence displayed
Enter up to 32 keystrokes. A speed key
sequence can include different
commands. Press the "D" key to
separate different commands.
For example, you may want to perform the following sequence.
GOTO partition 2................... Enter *2
Bypass zones 010 & 011...... Press bypass [6], then the zone
numbers 10 & 11
Arm in maximum mode............. Press maximum [4] key
Return to partition 1 ................ Enter *1
To program this sequence, type the following :
*2 D
6010011 D 4D*1 D D
Note that the "D" key is pressed after the "2," the last "1" and the
"4," separating the different commands. Press "D" twice to
complete the entry and exit.
NOTE: When defining speed key sequences, do not use the [#] key
to represent Quick Arming. The system uses the code entered at the
prompt to initiate commands in a speed key sequence. The system
interprets the use of the [#] key in a speed key sequence as its
designated function only.
Executing Press and hold down the appropriate lettered key (about 2 seconds)
until the following prompt appears:
ENTER USER CODE
✴✴✴✴
Enter your user code. The defined
speed key sequence will begin
automatically.