User guide

– 29 –
SECURITY CODES
& AUTHORITY LEVELS
To Add a User IMPORTANT: Temporary users should not be shown how to
use any system function they do not need to know (e.g.
bypassing protection zones).
CODE
1. Enter Master or Manager code and press the 8 key.
2. Enter the new user's 3-digit User Number (002-150).
3. Enter 4-digit security code for that user. The following prompts
will appear.
ADD NEW USER?
0 = NO , 1 = YES
Enter 1 to add a new user code. Entering
0 will change the existing user's code to
the code entered in step 3. See Changing
A User's Code section.
USER NUMBER = 003
ENTER AUTH.LEVEL
Enter the authority level, 1-6, for this user
within this partition.
1=master 4=operator B
2=manager 5=operator C
3=operator A 6=duress code
ACCESS GROUP?
ENTER 0-8
This prompt will appear if access
schedules havbe been programmed.
Enter the user's access group number (1-
8) if this user should have limited access to
the system. Enter 0 if no access group
should be assigned.
RF BUTTON ?
0 = NO , 1 = YES
This prompt will appear if a 5800 series
button transmitter has been supplied and
has not yet been assigned to a user. Press
1 if a button transmitter will be assigned to
this user. Otherwise press 0.
ENTER BUTTON ZN #
(001-128)
If assigning a button transmitter, this
prompt will appear. Enter the button's
zone number (see your installer for zone
number).