User`s manual

VISTA-50PEN Installation and Setup Guide
29-6
ENTER USER CODE
✴✴✴✴
Enter your user code. The programmed Speed Key sequence will begin automatically.
To activate a Speed Key not assigned to the A-B-C keys, press and hold down the [D] key for
2 seconds until the following prompt appears:
ENTER SPEED KEY #
01-32 00=QUIT
Enter the desired Speed Key number.
If a user code is required for any part of the Speed Key sequence, the following prompt
appears. Otherwise, the Speed Key sequence automatically begins.
ENTER USER CODE
✴✴✴✴
Enter your user code. The programmed Speed Key sequence will begin automatically.
The system will apply the user code’s Global Arming capabilities if the macro executes any arming
or disarming commands.
Manual Relay Activation Mode (#70 Mode)
The system allows users to manually activate relays by keypad command using either the
keypad or a telephone keypad (if VIP Module is used). The user will be prompted (either by
keypad alpha display or telephone voice module).
To activate relays from a keypad, enter 4-digit [Security Code] + [#] +70.
To activate relays using a telephone and VIP Module, first dial the 2-digit phone access code.
When the system acknowledges the access, enter 4-digit [Security Code] + [#] + 70. The
following prompts/voice responses will begin.
ENTER DEVICE NO.
00=QUIT 01
Voice: "ENTER DEVICE CODE NOW"
Enter the 2-digit number of the relay to be activated.
nn DEVICE IS OFF
HIT 0=OFF , 1=ON
Voice: “’VOICE DESCRIPTOR’ DEVICE ‘NN’ ON/OFF. FOR
‘VOICE DESCRIPTOR’ ON, ENTER 1; FOR ‘VOICE
DESCRIPTOR’ OFF ENTER 0"
Press 0 or 1 to turn the device off or on respectively.
‘NN’ represents the 2-digit relay number and ‘VOICE
DESCRIPTOR’ is the relay voice descriptor programmed by the
installer (see Relay Voice Descriptors in the #93 Menu Mode).