User Guide

Security Codes & Authority Levels (cont’d)
– 19 –
To Add a User
IMPORTANT:
Temporary users should not be shown how to use any
system function they do not need to know (e.g. bypassing protection
zones).
CODE
1. Enter Master or Manager code and press the 8 key.
2. Enter the new user's 2-digit User Number (02-99).
3. Enter 4-digit security code for that user. The following prompts
will appear.
ADD NEW USER?
0 = NO , 1 = YES
Enter 1 to add a new user code. Entering 0
will change the existing user's code to the
code entered in step 3. See Changing A User's
Code section.
USER NUMBER = 3
ENTER AUTH. LEVEL
Enter the authority level, 1-6, for this user
within this partition.
1=master 2=manager 3=operator A
4=operator B 5=operator C 6=duress code
RF BUTTON ?
0 = NO , 1 = YES
This prompt will appear if a 5800 series
button transmitter has been supplied and has
not yet been assigned to a user. Press 1 if a
button transmitter will be assigned to this
user. Otherwise press 0.
ENTER BUTTON ZN #
(01-64)
If assigning a button transmitter, this prompt
will appear. Enter the button's zone number
(see your installer for zone number).
MULTI-ACCESS ?
0 = NO , 1 = YES
If you as a user have access to other
partitions, the keypad will prompt for ability
of this new user to access (GOTO) those
partitions. Press 0 (NO) or 1 (YES). If no, the
system activates this user code and exits “Add
a User” mode. If yes, the keypad prompts for
the Global Arm option for this user.