Install Instructions

K
J
G
G
H
1
H2
D
L No. of M
Installation and servicing
M01708 LF2-01-02602 V2
CAUTION:
MagnaClean filter contains strong magnets. Keep away from
all electrical devices, bank cards and other magnetic devices.
MagnaClean filter contains strong magnets. Caution should
be taken at all times when handling if you have a pacemaker
fitted.
MagnaClean filter is a pressurized device.
Always release pressure before servicing.
Unit may be hot in operation. Handle with care.
A carbon neutral company
© ADEY Holdings (2008) Limited 2016. All rights reserved.
The ADEY® and MagnaClean® logos and word marks are Registered Trademarks of ADEY Holdings (2008) Limited used under sub license by ADEY Innovation LLC.
The MagnaClean CommercialTM word mark is a trademark of ADEY Holdings (2008) Limited used under sub license by ADEY Innovation LLC.
Product code Filter size Filter diameter
(inch)
Inlet size
(inch)
No. of magnetic
rods
Filter volume
(US gallons)
Filter dry
weight (lbs)
FL1-03-2700 2” 6.30 2 5 0.83 54.7
FL1-03-2701 3” 8.27 3 6 1.84 88.6
FL1-03-2702 4” 8.50 4 7 2.18 103.4
FL1-03-2703 6” 12.76 6 9 7.4 211.4
FL1-03-2704 8” 12.76 8 9 8.7 241.4
Filter
size
Flange thickness
(inch)
Bolt size Bolt
quantity
Bolt hole
PCD (inch)
2” 0.79 5/8” 4 4.75
3” 0.98 5/8” 4 6.00
4” 0.98 5/8” 8 7.50
6” 1.02 ¾” 8 9.50
8” 1.14 ¾” 8 11.75
Inlet and outlet flanges
Size options: 2”, 3” 4”, 6”, 8”
Flanges: ASME B16.5 Class 150
Technical specifications
MagnaClean
Maximum working pressure: 145 psi
Maximum working temperature: 212°F
Casing
Housing and lid material: 304L stainless steel (SA351CF3)
Drain: 1¼” FEMALE NPT hole, with 1¼” MALE NPT plug
Lid Seal: EPDM
Flow flanges
ASME B16.5 Class 150
Supplied with IBC gaskets (EPDM)
Magnets
Material: High power, NdFeB
Pocket sleeves: 304L Stainless steel (SA351CF3)
MagnaClean designed, manufactured and third party
approved to ASME Boiler and Pressure Vessel Code
Section VIII Division 1 - 2015
Toll free: 844 378 0442 | Office: 412 406 8292 | Email: [e-mail]
adeyusa.com
Servicing instructions
NOTE: Do not remove the magnets completely out of the filter. Individual magnets, during servicing, are to be lifted slowly
to the service position only. If a magnet is entirely removed, care should be taken at all times to ensure the magnets are not
placed near another metallic/magnetic source.
It is necessary to keep the magnets and pockets dry at all times.
(If gaskets are lost or damaged please contact ADEY on 844 378 0442)
3.
3. Either connect a hose to the 1¼” NPT drain valve
or place a bucket underneath the unit. Open the
drain valve or remove the drain plug.
2. To position the magnets into service mode, lift
and hold the gray locking ring, then carefully pull up
the magnet. Release the locking ring and continue
to slowly lift the magnet assembly until it locks into
service position. Ensure that the magnets are not
taken out from the filter completely.
2.
1. Turn off the boiler and isolate the electrics. Close
the isolation valves on either side of the MagnaClean
Commercial unit, then open the air vent.
1.
6. To replace the magnets to operational mode, lift
and hold gray locking ring up and slowly push down
magnet assembly. Release locking ring and continue
to slowly push down magnet assembly until it locks
into operational mode.
6.
5. Once the water runs clear, close the inlet isolation
valve, then close the drain point by turning off the
drain valve or replacing the plug. Close the air vent.
5.
4. Slightly open the inlet isolation valve, leaving the
other isolation valve closed, and allow the deposits
to drain through.
4.
7. Re-open both isolation valves then refill the
system as required. Bleed the air from the filter using
the air vent. Ensure all magnets and pockets remain
dry at all times and any excess fluid is wiped off the
top plate.
7.
1
1
1
1
1
1
2
2
2
2
Any queries should be directed to ADEY on 844 378 0442
For the most up-to-date version of installation and servicing instructions visit adeyusa.com
Service warranty
The product is backed by a two year warranty.
These instructions are designed to support installers in the safe and effective installation and servicing of MagnaClean Commercial.
2
1
3
4
5
SELF
LOCKING
RELEASE
HOLD
SLOWLY
2
1
LIFT AND
HOLD
3
RELEASE
4