Install Instructions

FOR BEST RESULTS
Install and service with MC1+ Protector, the advanced system
inhibitor from ADEY, the industry leaders in heating system
maintenance and water treatment.
2
Installation and servicing instructions
M08610 LF2-01-02594
MagnaClean
®
Micro2 incorporates a secure, quick-release, trigger which
enables the filter to be removed and re-installed in seconds.
The industry leading connections are an integral part of the new MagnaClean
Micro2 design. They enable easy and speedy filter removal during annual
servicing or to undertake a MagnaCleanse system flush. This also makes it ideal for
systems where there is little room to install a filter.
The following instructions are designed to support engineers in the safe and
effective servicing of MagnaClean Micro2 using the quick-release trigger.
Quick-release trigger
1
5
4
N.B. Periodically remove collets
and lubricate seals with water
Replace the collets,
quick-release trigger
and canister.
3
Turn locking pin 90˚
and remove
Replace locking pin
and turn 90˚ to lock
Toll free: 844 378 0442 | Office: 412 406 8292 | Email: [e-mail]
adeyusa.com
Maximum working pressure: 87 psi
Maximum working temperature: 203°F
Flow rate: Recommended rate for optimum capture up to 13 gallons per minute
Connection: ¾” Copper compression for copper pipework with ¾” FTG to ¾” NPT female
adapters for black iron pipework
CAUTION:
MagnaClean filter contains a strong magnet. Keep away from all electrical
devices, bank cards and other magnetic devices.
MagnaClean filter contains a strong magnet. Caution should be taken at all
times when handling if you have a pacemaker fitted.
MagnaClean filter is a pressurized device. Always release pressure
before servicing.
Unit may be hot in operation. Handle with care.