Specifications

5-78 Menus and Commands
600561-A
Target ID Dialog
When
Target ID
is selected, the Target ID Dialog is
displayed. See Figure 5-92. This option sets the SCSI ID of the
library. Any change will not take effect until library power is
cycled.
Figure 5-92 Target ID Dialog
Step 1 Press the button to select the current
parameter value and move to the next parameter.
— or —
Press the button or the button to toggle
between the parameter values in the following list.
Parameters Values
Bus 0: NEXT Next indicates the SCSI ID
address that takes effect for
bus port 0 after power is cycled
(0 .. 7)
Bus 1: NEXT Next indicates the SCSI ID
address that takes effect for
bus port 1 after power is cycled
(0 .. 7)
Accept Y to accept changes
N to reject changes
Press the button to confirm the changes.
Step 2 Repeat Step 1 for all of the parameters in the list.
The value of the Bus 1 : Now parameter in the
Target ID Dialog is supplied by the library
firmware and can not be changed. The Bus 1 : Now
parameter indicates the SCSI ID address that is
currently in effect (0 .. 7) for bus port 0.
Note
The Scalar 1000
defaults to SCSI
ID 6.
Target ID: Next Now
Bus 0: 4< 4
Bus 1: 4 4
Accept: N