Specifications

5-160 Menus and Commands
600561-A
Move Dialog
When
Move
is selected, the Move Dialog is displayed. See
Figure 5-174. This options moves the accessor in a figure eight
pattern without accessing cartridges.
Figure 5-174 Move Dialog
Step 1 Press the button to select the current
parameter value and move to the next parameter.
— or —
Press the button or the button to toggle
between the parameter values in the following list.
Parameters Values
Cycles to Run Indicates the desired cycle
count (001 .. 999)
Accept Y to accept changes
N to reject changes
Press the button to confirm the changes.
Step 2 Repeat Step 1 for all of the parameters in the list.
If
Y
is selected for the Accept parameter value, the
Response Screen appears. Refer to Figure 5-175 on page
5-161. Otherwise, the changed parameters continue to
display but no action is taken.
The accessor test
does corner moves.
Cycles to run: 009<
Accept: N