Specifications

Scalar 1000 Restart 4-39
01 Aug 2000
Step 4 Repeat Step 2 and Step 3 for each additional
Expansion Module.
Emergency Shutdown
Use the following procedure if an emergency situation arises.
Except in emergencies, stop the Scalar 1000 with the normal
shutdown procedure before switching off the Main Power
Switch. ADIC is not responsible for damage caused by
improper use of the Main Power Switch. All risk lies
entirely with the user.
With the RMU installed, power up must be delayed by at
least 10 seconds after a power down condition to allow the
RMU to properly shutdown.
Step 1 Locate the Main Power Switch at the lower right
corner in the back door panel of the Control
Module.
Step 2 Push in the bottom of the rocker the Main Power
Switch.
Power is removed from the Scalar 1000. All Accessor
movements halt immediately.
Step 3 Repeat Step 1 and Step 2 for any additional
Expansion Module.
Scalar 1000 Restart
Use the following procedure to restart the Scalar 1000.
With the RMU installed, power up must be delayed by at
least 10 seconds after a power down condition to allow the
RMU to properly shutdown.
Step 1 If applicable, correct any situations that required
the Scalar 1000 shutdown.
Step 2 Refer to
Scalar 1000 Startup
on page 4-37 for
instructions on the Scalar 1000 start procedure.
Attention
Caution
Caution