Installation and Operating Guide Scalar Series

EMI/RFI Compliance

United States – FCC

WARNING: This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy

and, if not installed and used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television reception (which can be determined by turning

the equipment off and on) the user is encouraged to try to correct the interference by one or more of the following

measures:

• Re-orient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

You may find the following booklet prepared by the Federal Communications Commission helpful: How to

Identify and Resolve Radio-TV Interference Problems. This booklet is available from the US Government Printing

Office, Washington, DC 20402, Stock No. 004-000-00354-04.

Any changes or modifications not expressly approved by adic could void the user's authority to operate this

equipment.

Canada – Department of Communications

This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus as set out

in the interference-causing equipment standard entitled "Digital Apparatus", ICES-003 of the Department of

Communications.

Cet appareil numérique respecte les limites de bruits radioélectriques applicables aux appareils numériques de

Class B prescriptes dans la norme sur le matériel brouilleur: "Appareils Numériques", NMB-003 édictée par le

ministre des Communications.

Shielded Cables

Shielded data cable(s) are required in order to meet EMI/RFI limit specifications. The adic data cable meets this

requirement. If you need a replacement cable, be sure to use an adic-approved shielded cable (to assure

acceptability to EMI/RFI requirements).