Application Guide

Skype and Q&A Face book group: ADIMLab 3D Printer
Contact: [e-mail] Skype: ADIMLab 3D Printer facebook group: ADIMLab 3D Printer
（4）nozzle temp can’t heat up well：
①the heater can’t heat up, or there is no value for the LCD.
solution：
a. Check if the heater and sensor fasten well in the hot end hole.
b. measure the resistance of the heater bar(about 14.5Ω) and the thermal
thensor(about 15kΩ).
c. if there is no problem, please check the voltage of the heater port, it
should be about 24V.