TM Operating Instructions AdirMed 970-01 Mechanical Height Measuring Rod
Operating Instructions 1.
Operating Instructions 2. 1. Wall assembly Set marking at 51.5 cm above the floor, using a verified length measuring device. 4. Insert the dowels. 51.5 cm 2. Extend height measuring rod and mark the second hole vertically above it. 5. Insert lower screw and tighten it. 3. Drill both holes. 6. Insert upper screw and tighten it.
Operating Instructions 3. How to attach to scale 1. Use the 2 screws for screwing the bracket into the supplied insert nuts on the stand of the scales. 2.
Operating Instructions 3. Body height measurement Body height above 130 cm A 1. Pull measuring rod upwards. 2. Move head stop up into horizontal position until it locks. 3. Carefully push the measuring rod down until the head stop gently touchesthe head of the aligned person. Read body height on the measuring rod (marking A). Body height below 130 cm B 1. Press locking and keep it pressed. 2. Shift head stop downwards. Then move head stop up into horizontal position until it locks. 3.
