LDG -8 Receiver operating manual www.adirpro.
Specifications Weight 7.1 oz Dimensions 2.75" x 5.5" x 1" Housing Plastic rubber with trimming Accuracy Fine: ±1 mm; Coarse: ±2.
LCD Display Coarse grade sensitivity Fine grade sensitivity Above reference high frequency beep) should move down Reference (long beep) Below reference low frequency beep) should move up Volume Icon Battery Level Indicator
Control Panel Magnetic strip – Allow you to affix receiver on any metal surface LCD - Front display shows the elevation, grade sensitivity, audio, and battery status Laser Receptor - Hold the laser receptor. Face the rotary laser to measure the accuracy Mark - The marking notch is 4.5 mm (1.75”.
Back Panel LCD –Back display shows the elevation, grade sensitivity, audio, and battery status ¼” Thread mounting nut – The clamp securely attaches here Battery compartment – Holds the battery securely in place
1. Open the battery door using a coin or your thumbnail. 2. Install/Remove the 9V battery noting the positive (+) and negative (–) diagram inside the housing. 3. Push down on the battery door until it “clicks” into position.
General Purpose Clamp The general purpose clamp allows the receiver to be attached to a grade rod or wooden pole.
AdirPro Irvington NJ 07111 customersupport@adircorp.com www.adirpro.