User manual

ADJ Products, LLC - www.adj.com - WiFly EXR QA5 IP User Manual Page 15
WiFly EXR QA5 IP Operating Instructions
scroll through the DMX Channel modes.
4. After you have chosen your desired DMX Channel mode plug in
the fixture via the XLR connections to any standard DMX con-
troller.
Battery Life:
This is used to check/display the battery life.
1. Plug the fixture in and press the MODE button until “BATT LEV
XXX” is displayed. “XXX” represents the remaining battery life. If
“BATT LEV ----” is displayed, it means either the battery is dead or
your running the unit on AC power.
Battery Load:
This is used to activate the PC board On.
1. Press the MODE button until “BATT LEV” is displayed.
2. Press the SET UP button until “BATT LEV LOAD:XX” is displayed.
“XX” represents either “ON” or “OFF”.
3. Press the UP or DOWN button so that “ON” is displayed. If “ON”
is displayed already then the PCB is active.
Default Running Mode:
This is a default running mode. When this mode is activated all modes
will return to their default settings.
1. Plug the fixture in and press the MODE button until “OPTION
BLGT:XX” is displayed. “XX” represents either “on” or “oFF”.
2. Press the SET UP button until “SYSRESET” is displayed.
3. Press the UP and DOWN buttons simultaneously to reset to
default settings.
ADJ RFC:
This function is used to activate and deactivate the ADJ RFC (Remote
Control). When this function is activated you can control the fixture
using the ADJ RFC. Please see the next page for ADJ RFC controls
and functions.
1. Plug the fixture in and press the MODE button until “OPTION” is
displayed.
2. Press the SET UP button until “RFXX” is displayed. “XX” repre-
sents either “ON” or “OFF”.
3. Press the UP or DOWN buttons to either activate the remote func-
ADJ Products, LLC - www.adj.com - WiFly EXR QA5 IP User Manual Page 20
WiFly EXR QA5 IP ADJ RFC Operation
The ADJ RFC remote (sold seperately) has many different functions and
allows you to control your WiFly EXR QA5 IP from long distance. The ADJ
RFC remote can control your system up to 150 ft. To use the RFC you must
first activate the fixtures receiver, to activate the receiver please see the in-
structions on page 15.
BLACKOUT - Pressing this button will blackout the fixture. Press this button
for more then 3 seconds to return to default settings.
AUTO RUN - Pressing this button will cycle through auto run, color change
mode, and color fade mode. In the color change and color fade modes
you can use the “+” and “-” buttons to find scroll through the 16 different
programs. You can control the speed of each of the modes by pressing the
SPEED button and using the “+” and “-” buttons.
PROGRAM SELECTION - Pressing this button will switch between static
color mode and slave mode. Use the “+” or “-” to scroll through the 64 static
colors. Once you have found your color, you can press the FLASH button to
activate strobing and use the “+” or “-” to adjust the flash rate.
FLASH - This button will activate the flash (strobe) effect. You can control
the flash speed using the “+” and “-” buttons.
SPEED - Press this button and use the “+” & “-” buttons to adjust the speed
in Program mode.
SOUND ACTIVE - This button is not used with fixture.
R G B W/A - Press either one of these buttons and use the “+” or “-” to ad-
just the brightness. Press the FLASH button to activate strobing and use the
“+” or “-” buttons to adjust the Flash rate.
“+” and “-” - Use these buttons to adjust the flash rate, select your desired
color change and color fade programs, adjust the color change speed, color
fade speed, auto run speed, RGBA brightness, and to scroll through the
Static colors.